Tetra Radio E&M port config

[asheel]

Hi All,

I am looking to get some cables from networked radio for the 880i eads tetra radios, he makes a cable that goes from the hands-free accessories port to an E&M port, has anyone tried this before? Please share any experiences config and I will do the same!

Cheers,
Andy

[asheel]

Hi all,

I got hold of the cables and have got Tetra interfaced with wave via the E&M port, here's the config in case any one else needs it:

voice-port 0/2/0
auto-cut-through
voice-class permanent 1
operation 4-wire
type 3
signal lmr
lmr e-lead voice
lmr duplex half
output attenuation 27
no comfort-noise
timeouts call-disconnect 3
timing hookflash-in 0
timing hangover 100
timing ignore m-lead 125
connection trunk 1112
description TETRA RADIO
!

and the dial-peer is the same as other E&M port integrations...

dial-peer voice 100 voip
description TETRA RADIO
destination-pattern 1112
voice-class h323 1
session protocol multicast
session target ipv4:234.1.11.1:21890
dtmf-relay h245-alphanumeric
codec g711alaw
!

Cheers,
Andy

[llamprecht]

Great, thanks for sharing this!